Do you frame basement developments in Southwood?

Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Pine Creek, Alpine Park, Osprey Hill and every Calgary quadrant.

Do you frame load-bearing walls?

No — we frame interior, non-load-bearing walls and bulkheads only. Anything structural needs a licensed structural engineer, and we will tell you when that is the case.

Can the same crew do the drywall after framing in Southwood?

Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.

Do you build bulkheads around ducting in Southwood?

Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.

Do you coordinate with my electrician and plumber?

Yes — we sequence the framing so your other trades can rough in cleanly before insulation and drywall.

Our Southwood ceiling cracks along the same line every winter — why?

That's typically truss uplift — the roof trusses lift slightly in cold, dry months and open a crack at the ceiling/wall joint. We repair it and can finish it so it's far less likely to telegraph back.

Framing Southwood Calgary | Basement Framing

Framing in Southwood, square and ready for drywall

Turning an unfinished basement or an open floor plan into real rooms starts with the frame. In Southwood we build wood-frame basement development layouts and interior partition walls — squared, plumbed and spaced for the drywall going over them. We frame interior, non-load-bearing walls only; a licensed structural engineer handles anything load-bearing. Southwood is an older SW Calgary community where settling cracks, aging texture and the occasional plaster repair come up, so framing here often means reworking walls that have shifted or been altered over the decades, alongside basement development. The same crew that frames can board, tape and finish too, so there is no handoff between trades. We cover Southwood, Pine Creek, Alpine Park, Osprey Hill and every Calgary quadrant, 7 days a week.

Wood-frame basement development layouts in Southwood
Interior partition walls framed square and plumb
Bulkheads and soffits for ductwork and lighting
Door rough openings framed to spec
Stud spacing matched to the drywall going over it
Frame-to-finish: one crew frames, boards, tapes and finishes
Southwood coverage — we come to you

What affects the cost of framing in Southwood?

Wall length, layout and openings

Framing cost in Southwood tracks the total wall length, the complexity of the layout, and the number of openings and bulkheads. We price off a site walk-through and give a fixed number before we start.

Typical framing work in Southwood homes

Because Southwood is an older SW Calgary community where settling cracks, aging texture and the occasional plaster repair come up, framing here often means reworking walls that have shifted or been altered over the decades, alongside basement development.

Our Southwood framing process, step by step

Layout before lumber

We chalk the plate lines from the plan or your walk-through direction and confirm every wall location in your Southwood space before anything is cut.

Square, plumb, spaced right

We frame the walls square and plumb with stud spacing matched to the board going over them — the frame stage is where a wavy wall gets built or avoided. See our basement drywall work in Southwood for the stage that follows.

Basement development framing in Southwood

From open concrete to real rooms

A basement development layout is the most common framing job we do in Southwood — bedrooms, a bathroom, a media room or a suite, framed to plan and ready for the trades that follow.

Interior and non-load-bearing only

We keep our framing to interior, non-load-bearing walls and bulkheads. Anything structural belongs with a licensed structural engineer — and we will tell you honestly when that is what your project needs.

Common framing situations in Southwood

Decades of Calgary freeze-thaw cycles show up in Southwood as recurring hairline cracks at door and window corners — we repair them properly (not just a smear of filler) so they are far less likely to reopen the following winter. Free on-site quote, one fixed price, and work that holds up after.

Why Southwood homeowners trust Emplastrum for framing

Framed by the people who finish it

As a drywall and finishing company first, we frame walls the way we want to board and tape them — square, plumb and consistent — because no amount of mud hides a crooked frame in Southwood.

Fixed price, same-day reply

We cover Southwood, Pine Creek, Alpine Park, Osprey Hill and every Calgary quadrant, 7 days a week. Free on-site quotes and fixed prices, and we stand behind the work.

How it works

Simple, clean, on schedule — Framing in Southwood Calgary

Free quote

We come out to your Southwood Calgary property, take a real look at the framing, and hand you a fixed price on the spot — no guessing, no vague ballpark. Every framing quote in Southwood Calgary starts with an honest, on-site assessment.

Book a day

We pick a day that works for your schedule and show up on time, ready to start the framing in Southwood Calgary. No back-and-forth rescheduling — once it's booked, our team is there.

The work

We keep the dust under control and protect your Southwood Calgary home while we finish the framing to a clean, paint-ready standard. Floors covered, doors sealed off, and the site left tidy at the end of every day.

Walk it with you

We don't pack up till you've walked the finished framing with us and you're happy with the result in Southwood Calgary. If anything needs a second look, we handle it before we call the job done.

Reviews

Rated by Calgary Homeowners

★ ★ ★ ★ ★

Emplastrum Drywall is the framing contractor Southwood Calgary trusts for repair, restoration and finishing — rated on Google by Calgary homeowners.

Read the reviews, or leave your own after your framing project in Southwood Calgary.

Read our reviews on Google

FAQ — Framing Southwood

Framing Southwood: your questions answered

Do you frame basement developments in Southwood?: Yes — wood-frame basement layouts ready for drywall are our most common framing job. We also cover Pine Creek, Alpine Park, Osprey Hill and every Calgary quadrant.
Do you frame load-bearing walls?: No — we frame interior, non-load-bearing walls and bulkheads only. Anything structural needs a licensed structural engineer, and we will tell you when that is the case.
Can the same crew do the drywall after framing in Southwood?: Yes — one crew frames, boards, tapes and finishes, so nothing gets lost in a handoff between trades.
Do you build bulkheads around ducting in Southwood?: Yes — bulkheads and soffits to box in ductwork, plumbing and lighting are part of nearly every basement frame.
Do you coordinate with my electrician and plumber?: Yes — we sequence the framing so your other trades can rough in cleanly before insulation and drywall.
Our Southwood ceiling cracks along the same line every winter — why?: That's typically truss uplift — the roof trusses lift slightly in cold, dry months and open a crack at the ceiling/wall joint. We repair it and can finish it so it's far less likely to telegraph back.

Need Calgary’s go-to drywall contractor for repair, restoration and finishing? One trusted team for boarding, taping, finishing, repairs & renovations — start to finish.

Your Drywall Contractor in Calgary →

Get Your Free Drywall Quote

Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.

Full Name / Company

Phone Number

Email Address

Area

Service Needed

I agree to be contacted by Emplastrum Drywall about my project by phone, text, or email.

No obligation. We never share your information.

📐 Plan Your Project

Estimate Your Drywall Materials

📐 Materials Calculator

How much do you need?

Enter your room size for a quick materials estimate.

Room length (ft)Room width (ft)Ceiling height (ft)Number of rooms Include ceilingSheet sizeCoats of paint

Estimate only — rounded up, based on standard coverage rates (drywall +10% waste; paint ~350 sq ft per gallon per coat). Confirm quantities before buying.

Rather we handle it? Get a free estimate →

Framing Southwood

Framing in Southwood, square and ready for drywall