Free on-site quotes7 days a weekNW Calgary · NE Calgary · SW Calgary · SE CalgaryLocally owned & operatedThe Go-To Drywall Contractor for Repair, Restoration & Finishing

Vapour barrier installation in Point McKay, sealed before the board goes on

A vapour barrier is one of the few things in a build that is completely hidden and completely unforgiving — once the drywall is on, a torn sheet or an unsealed outlet box stays that way for the life of the wall. In Point McKay we install and seal 6 mil poly over the insulation on the warm side, lapped at the seams and sealed at every penetration, before any board goes up. Point McKay is a mature inner-NW Calgary community where condo and reno drywall are common, so basement development and the occasional upgrade where older insulation has settled or thinned are common here. We cover Point McKay, Glacier Ridge, Medicine Hill, Haskayne and every Calgary quadrant, 7 days a week.

Vapour Barrier Point McKay

Watch vapour barrier installation jobs in Point Mckay Calgary on our YouTube channel

What affects the cost of vapour barrier installation in Point McKay?

Area, penetrations and detailing

Vapour barrier cost in Point McKay depends on the wall and ceiling area being covered, the number of penetrations that need sealing — outlets, vents, pipes and light boxes — and how much detail work the rim joist and window returns need. We measure the space and give a fixed price before we start.

Usually priced with the insulation

Most Point McKay vapour barrier work is quoted together with the insulation and the boarding that follows it, because it is the same crew and the same visit. In Point McKay we see everything from original finishes to recent renovations on the same block.

Which side the vapour barrier goes on, and why that is not optional

The warm side, always

In Point McKay the barrier goes on the warm side of the insulation — the side facing into the heated Point McKay room. That is what stops indoor moisture from travelling into the wall cavity and condensing when it reaches cold framing.

What goes wrong when it is reversed

A barrier installed on the cold side traps moisture inside the assembly instead of keeping it out. It is one of the few mistakes in a Point McKay wall that cannot be corrected without opening the wall back up, which is exactly why we check every Point McKay job before anything is covered. Point McKay spans a range of build eras, so what is behind the wall differs street to street.

How we install and seal it in Point McKay

Hung, lapped and sealed

We run the poly in the largest sheets the space allows to keep seams to a minimum, lap every seam over a stud or joist rather than in open cavity, and seal it — a stapled overlap on its own is not a seal.

The penetrations are the job

Outlet and switch boxes, bath fans, dryer vents, plumbing stacks and pot lights each get sealed individually in your Point McKay home. Poly on the walls with open boxes behind it is not a working vapour barrier, and it is the single most common thing we find on jobs that were started by someone else.

Common vapour barrier situations in Point McKay

Point Mckay's original ceilings were usually finished by hand, so no two rooms match exactly — we texture-match room by room rather than assuming one pattern covers the whole house. That is the standard on every job here, big or small — on-site quote, fixed price.

Why Point McKay homeowners have us do the vapour barrier

We are the ones boarding over it

As a drywall company we install the barrier the way we want to board over it, because we are the trade that has to live with what is behind the sheet in Point McKay.

Left ready to be looked at

We leave the barrier complete and visible so it can be inspected before the drywall goes on — nothing gets covered until it has been seen.

Fixed price, same-day reply

We cover Point McKay and every Calgary quadrant, 7 days a week. Free on-site quotes and a fixed price before any work starts. Point McKay spans a range of build eras, so what is behind the wall differs street to street.

Simple, clean, on schedule — Vapour Barrier Installation in Point Mckay Calgary

1

Free quote

Before anything is priced we walk the vapour barrier installation with you at the Point Mckay Calgary property. You get a fixed figure that day, not a range that moves later.

2

Book a day

We pick a day that works for your schedule and show up on time, ready to start the vapour barrier installation in Point Mckay Calgary. No back-and-forth rescheduling.

3

The work

Dust control is set up first — sheeting, sealed openings, containment — then the vapour barrier installation is taken through to a paint-ready finish in your Point Mckay Calgary home.

4

Walk it with you

Before we call the Point Mckay Calgary job finished we walk it together under proper light. If a spot needs another pass, it gets one.

Rated by Calgary Homeowners

Emplastrum Drywall is the vapour barrier installation contractor Point Mckay Calgary trusts for repair, restoration and finishing — rated on Google by Calgary homeowners.

Read what other people said, then tell us how we did on your own vapour barrier installation job in Point Mckay Calgary.

Read our reviews on Google

Vapour Barrier Point McKay: your questions answered

Does my basement development in Point McKay need a vapour barrier?
Almost always, yes — exterior basement walls in our climate need a barrier on the warm side of the insulation before drywall. We confirm what your specific assembly needs on the site visit rather than guessing from the plan.
Which side of the insulation does the poly go on in a Point McKay home?
The warm side — the side facing into the heated room. It is the detail that gets reversed most often, and it is not correctable once the wall is boarded.
Do you seal the outlet boxes and vents in Point McKay?
Yes — every outlet, switch box, vent and pipe penetration gets sealed individually. Poly hung over open boxes looks finished and does not work.
Do I still need a vapour barrier in Point McKay if I have spray foam?
Sometimes not — some spray foam assemblies act as their own barrier, and adding poly over them can be the wrong call. It depends on the product and the thickness, so we confirm on site instead of assuming.
Can you do the vapour barrier and the drywall together in Point McKay?
Yes — insulation, vapour barrier and boarding as one job is the most common way we do it, and it means one crew is responsible for what ends up behind the wall. We also cover Glacier Ridge, Medicine Hill, Haskayne and every Calgary quadrant.
We're renovating our Point Mckay home and found rough drywall behind old cabinets — can you fix that?
Yes — that's a common find in homes this age. We patch and skim it flush with the rest of the wall so it's ready for new cabinetry, tile or paint.
Emplastrum Drywall — Vapour Barrier Point McKay | Taping, Mudding, Ceilings & Painting

Other Drywall Services in Point Mckay Calgary — Taping, Mudding, Ceilings & Painting

We also serve nearby

Need Calgary’s go-to drywall contractor for repair, restoration and finishing? One trusted team for boarding, taping, finishing, repairs & renovations — start to finish.

Your Drywall Contractor in Calgary →

Everything else we handle in Point McKay

Drywall Tips & Guides — Point Mckay Calgary

Get Your Free Drywall Quote
Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.
No obligation. We never share your information.
📞  Call (403) 829-8702 Free Quote
See our latest drywall projects & updates on FacebookFollow Emplastrum Drywall — Calgary, Airdrie, Cochrane, Chestermere & Okotoks Follow on Facebook