Free on-site quotes7 days a weekNW Calgary · NE Calgary · SW Calgary · SE CalgaryLocally owned & operatedThe Go-To Drywall Contractor for Repair, Restoration & Finishing

Vapour barrier installation in Glenbow, sealed before the board goes on

A vapour barrier is one of the few things in a build that is completely hidden and completely unforgiving — once the drywall is on, a torn sheet or an unsealed outlet box stays that way for the life of the wall. In Glenbow we install and seal 6 mil poly over the insulation on the warm side, lapped at the seams and sealed at every penetration, before any board goes up. Glenbow is a Cochrane community where reno, repair and finishing drywall are common, so basement development and the occasional upgrade where older insulation has settled or thinned are common here. We cover Glenbow and all of Cochrane, 7 days a week.

Vapour Barrier Glenbow

Watch vapour barrier installation jobs in Glenbow Cochrane on our YouTube channel

What affects the cost of vapour barrier installation in Glenbow?

Area, penetrations and detailing

Vapour barrier cost in Glenbow depends on the wall and ceiling area being covered, the number of penetrations that need sealing — outlets, vents, pipes and light boxes — and how much detail work the rim joist and window returns need. We measure the space and give a fixed price before we start.

Usually priced with the insulation

Most Glenbow vapour barrier work is quoted together with the insulation and the boarding that follows it, because it is the same crew and the same visit. In Glenbow we see everything from original finishes to recent renovations on the same block.

Which side the vapour barrier goes on, and why that is not optional

The warm side, always

In Glenbow the barrier goes on the warm side of the insulation — the side facing into the heated Glenbow room. That is what stops indoor moisture from travelling into the wall cavity and condensing when it reaches cold framing.

What goes wrong when it is reversed

A barrier installed on the cold side traps moisture inside the assembly instead of keeping it out. It is one of the few mistakes in a Glenbow wall that cannot be corrected without opening the wall back up, which is exactly why we check every Glenbow job before anything is covered. Glenbow spans a range of build eras, so what is behind the wall differs street to street.

How we install and seal it in Glenbow

Hung, lapped and sealed

We run the poly in the largest sheets the space allows to keep seams to a minimum, lap every seam over a stud or joist rather than in open cavity, and seal it — a stapled overlap on its own is not a seal.

The penetrations are the job

Outlet and switch boxes, bath fans, dryer vents, plumbing stacks and pot lights each get sealed individually in your Glenbow home. Poly on the walls with open boxes behind it is not a working vapour barrier, and it is the single most common thing we find on jobs that were started by someone else. Glenbow spans a range of build eras, so what is behind the wall differs street to street.

Common vapour barrier situations in Glenbow

Drywall repair and finishing in Glenbow is handled the same careful way on every job. We repair holes, stress cracks, nail pops and water stains, then texture-match so the fix disappears. We handle renovation and new-construction drywall, boarding and finishing on schedule. Fast, clean and paint-ready, most repairs in a single visit. One fixed price after an honest on-site look, and the job done right the first time.

Why Glenbow homeowners have us do the vapour barrier

We are the ones boarding over it

As a drywall company we install the barrier the way we want to board over it, because we are the trade that has to live with what is behind the sheet in Glenbow.

Left ready to be looked at

We leave the barrier complete and visible so it can be inspected before the drywall goes on — nothing gets covered until it has been seen.

Fixed price, same-day reply

We cover Glenbow and all of Cochrane, 7 days a week. Free on-site quotes and a fixed price before any work starts. Glenbow spans a range of build eras, so what is behind the wall differs street to street.

Simple, clean, on schedule — Vapour Barrier Installation in Glenbow Cochrane

1

Free quote

Someone attends the Glenbow Cochrane address, inspects what the vapour barrier installation actually involves, and gives you a firm number before leaving. Nothing is estimated from a photo.

2

Book a day

One date, agreed and kept. The vapour barrier installation in Glenbow Cochrane starts when we said it would, with the right materials already on the truck.

3

The work

We work clean. The Glenbow Cochrane property is masked off before the vapour barrier installation starts and put back the way we found it, finished to a paint-ready standard.

4

Walk it with you

Before we call the Glenbow Cochrane job finished we walk it together under proper light. If a spot needs another pass, it gets one.

Rated by Cochrane Homeowners

Glenbow Cochrane homeowners come to Emplastrum Drywall for vapour barrier installation — repairs, restoration and a proper finish. Every review is a real one, left on Google by a Cochrane customer.

Read what other people said, then tell us how we did on your own vapour barrier installation job in Glenbow Cochrane.

Read our reviews on Google

Vapour Barrier Glenbow: your questions answered

Does my basement development in Glenbow need a vapour barrier?
Almost always, yes — exterior basement walls in our climate need a barrier on the warm side of the insulation before drywall. We confirm what your specific assembly needs on the site visit rather than guessing from the plan.
Which side of the insulation does the poly go on in a Glenbow home?
The warm side — the side facing into the heated room. It is the detail that gets reversed most often, and it is not correctable once the wall is boarded.
Do you seal the outlet boxes and vents in Glenbow?
Yes — every outlet, switch box, vent and pipe penetration gets sealed individually. Poly hung over open boxes looks finished and does not work.
Do I still need a vapour barrier in Glenbow if I have spray foam?
Sometimes not — some spray foam assemblies act as their own barrier, and adding poly over them can be the wrong call. It depends on the product and the thickness, so we confirm on site instead of assuming.
Can you do the vapour barrier and the drywall together in Glenbow?
Yes — insulation, vapour barrier and boarding as one job is the most common way we do it, and it means one crew is responsible for what ends up behind the wall. We also cover Cochrane, Sunset Ridge, Heritage Hills and the Cochrane area.
Do you do small drywall repairs in Glenbow or only big jobs?
Both — from a single patch, crack or nail-pop repair in Glenbow (often done in one visit) up to full basement finishing and renovations.
Emplastrum Drywall — Vapour Barrier Glenbow | Taping, Mudding, Ceilings & Painting

Other Drywall Services in Glenbow Cochrane — Taping, Mudding, Ceilings & Painting

We also serve nearby

Need Cochrane’s go-to drywall contractor for repair, restoration and finishing? One trusted team for boarding, taping, finishing, repairs & renovations — start to finish.

Your Drywall Contractor in Cochrane →

The rest of what we do in Glenbow

Drywall Tips & Guides — Glenbow Cochrane

Get Your Free Drywall Quote
Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.
No obligation. We never share your information.
📞  Call (403) 829-8702 Free Quote
See our latest drywall projects & updates on FacebookFollow Emplastrum Drywall — Calgary, Airdrie, Cochrane, Chestermere & Okotoks Follow on Facebook