Free on-site quotes7 days a weekNW Calgary · NE Calgary · SW Calgary · SE CalgaryLocally owned & operatedThe Go-To Drywall Contractor for Repair, Restoration & Finishing

Vapour barrier installation in Cochrane, sealed before the board goes on

A vapour barrier is one of the few things in a build that is completely hidden and completely unforgiving — once the drywall is on, a torn sheet or an unsealed outlet box stays that way for the life of the wall. In Cochrane we install and seal 6 mil poly over the insulation on the warm side, lapped at the seams and sealed at every penetration, before any board goes up. Cochrane is a Cochrane community where reno, repair and finishing drywall are common, so insulation calls here range from basement development in the newer homes to attic and wall upgrades in the older ones nearby. We cover all of Cochrane, 7 days a week.

Vapour Barrier Cochrane

Watch vapour barrier installation jobs in Cochrane on our YouTube channel

What affects the cost of vapour barrier installation in Cochrane?

Area, penetrations and detailing

Vapour barrier cost in Cochrane depends on the wall and ceiling area being covered, the number of penetrations that need sealing — outlets, vents, pipes and light boxes — and how much detail work the rim joist and window returns need. We measure the space and give a fixed price before we start.

Usually priced with the insulation

Most Cochrane vapour barrier work is quoted together with the insulation and the boarding that follows it, because it is the same crew and the same visit.

Which side the vapour barrier goes on, and why that is not optional

The warm side, always

In Cochrane the barrier goes on the warm side of the insulation — the side facing into the heated Cochrane room. That is what stops indoor moisture from travelling into the wall cavity and condensing when it reaches cold framing.

What goes wrong when it is reversed

A barrier installed on the cold side traps moisture inside the assembly instead of keeping it out. It is one of the few mistakes in a Cochrane wall that cannot be corrected without opening the wall back up, which is exactly why we check every Cochrane job before anything is covered.

How we install and seal it in Cochrane

Hung, lapped and sealed

We run the poly in the largest sheets the space allows to keep seams to a minimum, lap every seam over a stud or joist rather than in open cavity, and seal it — a stapled overlap on its own is not a seal.

The penetrations are the job

Outlet and switch boxes, bath fans, dryer vents, plumbing stacks and pot lights each get sealed individually in your Cochrane home. Poly on the walls with open boxes behind it is not a working vapour barrier, and it is the single most common thing we find on jobs that were started by someone else.

Common vapour barrier situations in Cochrane

New basement developments

insulation calls here range from basement development in the newer homes to attic and wall upgrades in the older ones nearby, so basement development is where most vapour barrier work comes up here — exterior walls and rim joist detailed before the drywall stage. See our basement drywall work if the boarding is part of the same job.

Renovations and open walls

When a wall in a Cochrane home is already open, it is the only practical moment to add or repair a barrier.

Repairing a damaged barrier

We also repair poly that has been torn by other trades after it went up — a common find once electrical and plumbing have been through.

Why Cochrane homeowners have us do the vapour barrier

We are the ones boarding over it

As a drywall company we install the barrier the way we want to board over it, because we are the trade that has to live with what is behind the sheet in Cochrane.

Left ready to be looked at

We leave the barrier complete and visible so it can be inspected before the drywall goes on — nothing gets covered until it has been seen.

Fixed price, same-day reply

We cover all of Cochrane, 7 days a week. Free on-site quotes and a fixed price before any work starts.

Simple, clean, on schedule — Vapour Barrier Installation in Cochrane

1

Free quote

We come out to your Cochrane property, take a real look at the vapour barrier installation, and hand you a fixed price on the spot — no guessing, no vague ballpark.

2

Book a day

We book around you, not around our week. When the day comes the Cochrane crew is there at the agreed time, loaded for the vapour barrier installation.

3

The work

The vapour barrier installation is done in a protected work area. Furniture and floors in the Cochrane home are covered, and nothing is left for you to clean up at the end of the day.

4

Walk it with you

The vapour barrier installation is not done when the tools are packed — it is done when you have walked it in Cochrane and told us it is right.

Rated by Cochrane Homeowners

Homeowners in Cochrane call Emplastrum Drywall for vapour barrier installation work, from a single patch through to a full restoration. Our reviews are on Google, written by Cochrane customers.

Read the reviews, or leave your own after your vapour barrier installation project in Cochrane.

Read our reviews on Google

Vapour Barrier Cochrane: your questions answered

Does my basement development in Cochrane need a vapour barrier?
Almost always, yes — exterior basement walls in our climate need a barrier on the warm side of the insulation before drywall. We confirm what your specific assembly needs on the site visit rather than guessing from the plan.
Which side of the insulation does the poly go on in a Cochrane home?
The warm side — the side facing into the heated room. It is the detail that gets reversed most often, and it is not correctable once the wall is boarded.
Do you seal the outlet boxes and vents in Cochrane?
Yes — every outlet, switch box, vent and pipe penetration gets sealed individually. Poly hung over open boxes looks finished and does not work.
Do I still need a vapour barrier in Cochrane if I have spray foam?
Sometimes not — some spray foam assemblies act as their own barrier, and adding poly over them can be the wrong call. It depends on the product and the thickness, so we confirm on site instead of assuming.
Can you do the vapour barrier and the drywall together in Cochrane?
Yes — insulation, vapour barrier and boarding as one job is the most common way we do it, and it means one crew is responsible for what ends up behind the wall. We also cover Sunset Ridge, Heritage Hills, Riversong and the Cochrane area.
Emplastrum Drywall — Vapour Barrier Cochrane | Taping, Mudding, Ceilings & Painting

Other Drywall Services in Cochrane — Taping, Mudding, Ceilings & Painting

We also serve nearby

Need Cochrane’s go-to drywall contractor for repair, restoration and finishing? One trusted team for boarding, taping, finishing, repairs & renovations — start to finish.

Your Drywall Contractor in Cochrane →

What else we can do while we are in Cochrane

Drywall Tips & Guides — Cochrane

Get Your Free Drywall Quote
Tell us about your project — we’ll get right back to you, 7 days a week. Prefer to call? (403) 829-8702.
No obligation. We never share your information.
📞  Call (403) 829-8702 Free Quote
See our latest drywall projects & updates on FacebookFollow Emplastrum Drywall — Calgary, Airdrie, Cochrane, Chestermere & Okotoks Follow on Facebook